6
Assembly Instructions — continued
8. Attach the ballast to the power
cord.Usecaretoalignthe4-pin
plug properly. DO NOT FORCE.
The 4-pin plug was designed to fit
inonlyoneorientation(Fig.3).
Fig. 3
9.Plugballastintoastandard120V50/60Hz
outlet. Turn lamp on. The green LED indicator
on center of the ballast should be illuminated
(Fig.4).IftheLEDindicatordoesnotilluminate,
please refer to the troubleshooting section of
thismanualmanual.(Seepage9.)
10. If bulb does not illuminate instantly, please
refer to the troubleshooting section of this
manual.
11.Adjustlampbrightnesstothedesiredlevel.
Fig. 4
Vents
Note: Do not
touch filter
material
7. Attaching the Optix
®
glare control
lter:
• Removeglarecontrollterfrom
protective plastic bag. Take
care to hold filter by the edges
only.
• Inserttabsonbottomoflter
intoopening(Fig.2).
• Pressintoplaceusing
thumb tab.
Do not touch or press
on the filter material itself.
Fig. 2
Do not block vents on ballast.
Vents are necessary for proper function of the
ballast. Blocking them may cause overheating of
the ballast and increase risk of fire.
VF03-MAN-Rev11.indd 6 10/9/13 2:51 PM
Comments to this Manuals