Verilux CLEANWAVE UV-C User Manual download pdf (Page 6)

ASSEMBLY INSTRUCTIONS

Before assembling, please review all instructions.

1. Carefully remove all parts from the box and make sure all parts listed on

the spare parts illustration are included. If any parts are missing, please

contact Verilux at 1-888-544-4865.

2. Assemble 3 shaft sections (A) according to the illustration and make sure

sections are joined together securely.

NOTE: The middle shaft section can be taken out when using Sweeper on

stairs or on upholstery

3. Remove Part B from the handle assembly by pulling it apart (photo 1). Fully

insert knurled end of shaft into handle assembly (photo 2). Slide Part B over

shaft, line up arrows on part B and handle assembly (photo 3), and push

together against handle assembly to lock shaft to the handle.

4. Your Sweeper was shipped with the “smart” battery disconnected from the

Sweeper. Prior to charging the battery, turn the Sweeper upside down, slide

the battery compartment door toward the rear of the Sweeper (see arrow on

cover door), insert the male connection of the battery wire into the female

connection of the Sweeper.

5. To charge the battery, plug included AC

Adapter/Battery Charger into the charger

socket on the side of the base of the Sweeper

and charge initially for 12 hours before using.

When charged, carefully remove the battery

charger cable prior to using. Never leave the

charger connected for longer than 24 hours at

a time.

6. Turn on power switch and begin to use

on proper surfaces.

1 2 3 4 5 6 7 8

No comments

Verilux CLEANWAVE UV-C User Manual Page 6